CAME VER KIT Instrukcja Użytkownika Pobierz pdf (Strona 21)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

File the edge of the opposite side in the same

manner as shown in photos 3.35 and 3.36.

Photo 3.37 Photo 3.38

Photo 3.39

Photo 3.40

ext, we will adjust the width of the frame into

which the servo motor fits. Since the inside was cut

out using nippers, it is a little too narrow. Gradually

file down the edges to adjust the width so that the

servo motor fits snugly.

Remove the black screws and servo back

reinforcing plates, then reclamp the plate as

shown in photo 3.38. File flat the edge indicated

In photo 3.41 there are burrs visible inside the

frame. File down the edges indicated by the dotted

lines a little at a time, alternating between the sides.

Photo 3.41

Photo 3.42

File the edges until the width roughly matches that of

the servo motor, as shown in photo 3.42. Check

periodically if the servo motor fits while adjusting

the width.

The outer edges of the servo support plate are all

flat.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 91 92

Brak uwag

CAME VER KIT Instrukcja Użytkownika Strona 21