CAME VER KIT Instrukcja Użytkownika Pobierz pdf (Strona 35)

Micon Car Kit, Ver. 5.1Body Assembly Manual (Version for RX62T)

Once the sensor arms have been attached as shown in photo 5.12, the next step is to attach the front shaft support

plate.

Photo 5.7

Photo 5.8

Prepare the parts shown in photo 5.7 and the quantity of screws, nuts, etc., shown in photo 5.8.

4 black screws

2 screw and washer

assemblies (dia. 3 × 15 mm,

washer dia. 6 mm)

6 nuts

4 s

rin

washers

Sensor

board

Spacers

Sensor

arm

Front shaft support plate

As shown in photo 5.9, insert from the underside of the

sensor board two screw and washer assemblies (dia. 3 ×

15 mm flat washer dia. 6 mm), one into each of the

holes marked 4 on the sensor

Photo 5.9 Photo 5.10

As shown in photo 5.11, fit the hole at the end of the

long portion of each sensor arm over the end of each

screw and secure it with a nut.

Photo 5.11

Photo 5.12

As shown in photo 5.10 place a spacer over the end

of each screw, with the large side on the bottom.

Front shaft support plate

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 91 92

Brak uwag

CAME VER KIT Instrukcja Użytkownika Strona 35